mirror of
https://github.com/arduino/Arduino.git
synced 2024-12-13 23:48:46 +01:00
54 lines
1.3 KiB
Plaintext
54 lines
1.3 KiB
Plaintext
|
/*
|
||
|
Button
|
||
|
|
||
|
Turns on and off a light emitting diode(LED) connected to digital
|
||
|
pin 13, when pressing a pushbutton attached to pin 7.
|
||
|
|
||
|
|
||
|
The circuit:
|
||
|
* LED attached from pin 13 to ground
|
||
|
* pushbutton attached to pin 2 from +5V
|
||
|
* 10K resistor attached to pin 2 from ground
|
||
|
|
||
|
* Note: on most Arduinos there is already an LED on the board
|
||
|
attached to pin 13.
|
||
|
|
||
|
|
||
|
created 2005
|
||
|
by DojoDave <http://www.0j0.org>
|
||
|
modified 17 Jun 2009
|
||
|
by Tom Igoe
|
||
|
|
||
|
http://www.arduino.cc/en/Tutorial/Button
|
||
|
*/
|
||
|
|
||
|
// constants won't change. They're used here to
|
||
|
// set pin numbers:
|
||
|
const int buttonPin = 2; // the number of the pushbutton pin
|
||
|
const int ledPin = 13; // the number of the LED pin
|
||
|
|
||
|
// variables will change:
|
||
|
int buttonState = 0; // variable for reading the pushbutton status
|
||
|
|
||
|
void setup() {
|
||
|
// initialize the LED pin as an output:
|
||
|
pinMode(ledPin, OUTPUT);
|
||
|
// initialize the pushbutton pin as an input:
|
||
|
pinMode(buttonPin, INPUT);
|
||
|
}
|
||
|
|
||
|
void loop(){
|
||
|
// read the state of the pushbutton value:
|
||
|
buttonState = digitalRead(buttonPin);
|
||
|
|
||
|
// check if the pushbutton is pressed.
|
||
|
// if it is, the buttonState is HIGH:
|
||
|
if (buttonState == HIGH) {
|
||
|
// turn LED on:
|
||
|
digitalWrite(ledPin, HIGH);
|
||
|
}
|
||
|
else {
|
||
|
// turn LED off:
|
||
|
digitalWrite(ledPin, LOW);
|
||
|
}
|
||
|
}
|