mirror of
https://github.com/arduino/Arduino.git
synced 2025-02-19 13:54:23 +01:00
This commit is contained in:
parent
b2678262b8
commit
75385f5ff5
@ -1,25 +1,39 @@
|
||||
/*
|
||||
* Blink
|
||||
*
|
||||
* The basic Arduino example. Turns on an LED on for one second,
|
||||
* then off for one second, and so on... We use pin 13 because,
|
||||
* depending on your Arduino board, it has either a built-in LED
|
||||
* or a built-in resistor so that you need only an LED.
|
||||
*
|
||||
* http://www.arduino.cc/en/Tutorial/Blink
|
||||
Blink
|
||||
|
||||
Turns on an LED on for one second, then off for one second, repeatedly.
|
||||
|
||||
The circuit:
|
||||
* LED connected from digital pin 13 to ground.
|
||||
|
||||
* Note: On most Arduino boards, there is already an LED on the board
|
||||
connected to pin 13, so you don't need any extra components for this example.
|
||||
|
||||
|
||||
Created 1 June 2005
|
||||
By DojoDave <http://www.0j0.org>
|
||||
http://arduino.berlios.de
|
||||
|
||||
based on an orginal by H. Barragan for the Wiring i/o board
|
||||
|
||||
*/
|
||||
|
||||
int ledPin = 13; // LED connected to digital pin 13
|
||||
int ledPin = 13; // LED connected to digital pin 13
|
||||
|
||||
void setup() // run once, when the sketch starts
|
||||
{
|
||||
pinMode(ledPin, OUTPUT); // sets the digital pin as output
|
||||
// The setup() method runs once, when the sketch starts
|
||||
|
||||
void setup() {
|
||||
// initialize the digital pin as an output:
|
||||
pinMode(ledPin, OUTPUT);
|
||||
}
|
||||
|
||||
void loop() // run over and over again
|
||||
// the loop() method runs over and over again,
|
||||
// as long as the Arduino has power
|
||||
|
||||
void loop()
|
||||
{
|
||||
digitalWrite(ledPin, HIGH); // sets the LED on
|
||||
delay(1000); // waits for a second
|
||||
digitalWrite(ledPin, LOW); // sets the LED off
|
||||
delay(1000); // waits for a second
|
||||
digitalWrite(ledPin, HIGH); // set the LED on
|
||||
delay(1000); // wait for a second
|
||||
digitalWrite(ledPin, LOW); // set the LED off
|
||||
delay(1000); // wait for a second
|
||||
}
|
||||
|
Loading…
x
Reference in New Issue
Block a user