/* MIDI note player This sketch shows how to use the serial transmit pin (pin 1) to send MIDI note data. If this circuit is connected to a MIDI synth, it will play the notes F#-0 (0x1E) to F#-5 (0x5A) in sequence. The circuit: - digital in 1 connected to MIDI jack pin 5 - MIDI jack pin 2 connected to ground - MIDI jack pin 4 connected to +5V through 220-ohm resistor Attach a MIDI cable to the jack, then to a MIDI synth, and play music. created 13 Jun 2006 modified 13 Aug 2012 by Tom Igoe This example code is in the public domain. http://www.arduino.cc/en/Tutorial/Midi */ void setup() { // Set MIDI baud rate: Serial.begin(31250); } void loop() { // play notes from F#-0 (0x1E) to F#-5 (0x5A): for (int note = 0x1E; note < 0x5A; note ++) { //Note on channel 1 (0x90), some note value (note), middle velocity (0x45): noteOn(0x90, note, 0x45); delay(100); //Note on channel 1 (0x90), some note value (note), silent velocity (0x00): noteOn(0x90, note, 0x00); delay(100); } } // plays a MIDI note. Doesn't check to see that // cmd is greater than 127, or that data values are less than 127: void noteOn(int cmd, int pitch, int velocity) { Serial.write(cmd); Serial.write(pitch); Serial.write(velocity); }