/*
  Blink
 
 Turns on an LED on for one second, then off for one second, repeatedly.
 
 The circuit:
 * LED connected from digital pin 13 to ground.
 
 * Note: On most Arduino boards, there is already an LED on the board
 connected to pin 13, so you don't need any extra components for this example.
 
 
 Created 1 June 2005
 By DojoDave <http://www.0j0.org>
 http://arduino.berlios.de
 
 based on an orginal by H. Barragan for the Wiring i/o board
 
 */

int ledPin =  13;    // LED connected to digital pin 13

// The setup() method runs once, when the sketch starts

void setup()   {                
  // initialize the digital pin as an output:
  pinMode(ledPin, OUTPUT);     
}

// the loop() method runs over and over again,
// as long as the Arduino has power

void loop()                     
{
  digitalWrite(ledPin, HIGH);   // set the LED on
  delay(1000);                  // wait for a second
  digitalWrite(ledPin, LOW);    // set the LED off
  delay(1000);                  // wait for a second
}