mirror of
https://github.com/arduino/Arduino.git
synced 2024-12-03 14:24:15 +01:00
76 lines
2.4 KiB
Plaintext
76 lines
2.4 KiB
Plaintext
/*
|
|
Conditionals - while statement
|
|
|
|
This example demonstrates the use of while() statements.
|
|
|
|
It reads the state of a potentiometer (an analog input) and blinks an LED
|
|
while the LED remains above a certain threshold level. It prints the analog value
|
|
only if it's below the threshold.
|
|
|
|
This example uses principles explained in the BlinkWithoutDelay example as well.
|
|
|
|
The circuit:
|
|
* potentiometer connected to analog pin 0.
|
|
Center pin of the potentiometer goes to the analog pin.
|
|
side pins of the potentiometer go to +5V and ground
|
|
* LED connected from digital pin 13 to ground
|
|
|
|
* Note: On most Arduino boards, there is already an LED on the board
|
|
connected to pin 13, so you don't need any extra components for this example.
|
|
|
|
created 17 Jan 2009
|
|
by Tom Igoe
|
|
|
|
*/
|
|
|
|
// These constants won't change:
|
|
const int analogPin = 0; // pin that the sensor is attached to
|
|
const int ledPin = 13; // pin that the LED is attached to
|
|
const int threshold = 400; // an arbitrary threshold level that's in the range of the analog input
|
|
const int blinkDelay = 500; // how long to hold between changes of the LED
|
|
|
|
// these variables will change:
|
|
int ledState = LOW; // the state of the LED
|
|
int lastBlinkTime = 0; // last time the LED changed
|
|
int analogValue; // variable to hold the value of the analog input
|
|
|
|
|
|
void setup() {
|
|
// initialize the LED pin as an output:
|
|
pinMode(ledPin, OUTPUT);
|
|
// initialize serial communications:
|
|
Serial.begin(9600);
|
|
}
|
|
|
|
void loop() {
|
|
// read the value of the potentiometer:
|
|
analogValue = analogRead(analogPin);
|
|
|
|
// if the analog value is high enough, turn on the LED:
|
|
while (analogValue > threshold) {
|
|
// if enough time has passed since the last change of the LED,
|
|
// then change it. Note you're using the technique from BlinkWithoutDelay
|
|
// here so that the while loop doesn't delay the rest of the program:
|
|
|
|
if (millis() - lastBlinkTime > blinkDelay) {
|
|
// if the ledState is high, this makes it low, and vice versa:
|
|
ledState = !ledState;
|
|
digitalWrite(ledPin, ledState);
|
|
|
|
// save the last time the LED changed in a variable:
|
|
lastBlinkTime = millis();
|
|
}
|
|
// while you're in the while loop, you have to read the
|
|
// input again:
|
|
analogValue = analogRead(analogPin);
|
|
}
|
|
|
|
// if you're below the threshold, print the analog value:
|
|
Serial.println(analogValue, DEC);
|
|
// turn the LED off:
|
|
digitalWrite(ledPin, LOW);
|
|
|
|
}
|
|
|
|
|