mirror of
https://github.com/arduino/Arduino.git
synced 2024-12-05 16:24:12 +01:00
59 lines
1.5 KiB
Plaintext
59 lines
1.5 KiB
Plaintext
/*
|
|
LED bar graph
|
|
|
|
Turns on a series of LEDs based on the value of an analog sensor.
|
|
This is a simple way to make a bar graph display. Though this graph
|
|
uses 10 LEDs, you can use any number by changing the LED count
|
|
and the pins in the array.
|
|
|
|
This method can be used to control any series of digital outputs that
|
|
depends on an analog input.
|
|
|
|
The circuit:
|
|
* LEDs from pins 2 through 11 to ground
|
|
|
|
created 26 Jun 2009
|
|
by Tom Igoe
|
|
|
|
http://www.arduino.cc/en/Tutorial/BarGraph
|
|
*/
|
|
|
|
|
|
// these constants won't change:
|
|
const int analogPin = 0; // the pin that the potentiometer is attached to
|
|
const int ledCount = 10; // the number of LEDs in the bar graph
|
|
|
|
int ledPins[] = {
|
|
2, 3, 4, 5, 6, 7,8,9,10,11 }; // an array of pin numbers to which LEDs are attached
|
|
|
|
|
|
void setup() {
|
|
// loop over the pin array and set them all to output:
|
|
for (int thisLed = 0; thisLed < ledCount; thisLed++) {
|
|
pinMode(ledPins[thisLed], OUTPUT);
|
|
}
|
|
}
|
|
|
|
void loop() {
|
|
// read the potentiometer:
|
|
int sensorReading = analogRead(analogPin);
|
|
// map the result to a range from 0 to the number of LEDs:
|
|
int ledLevel = map(sensorReading, 0, 1023, 0, ledCount);
|
|
|
|
// loop over the LED array:
|
|
for (int thisLed = 0; thisLed < ledCount; thisLed++) {
|
|
// if the array element's index is less than ledLevel,
|
|
// turn the pin for this element on:
|
|
if (thisLed < ledLevel) {
|
|
digitalWrite(ledPins[thisLed], HIGH);
|
|
}
|
|
// turn off all pins higher than the ledLevel:
|
|
else {
|
|
digitalWrite(ledPins[thisLed], LOW);
|
|
}
|
|
}
|
|
}
|
|
|
|
|
|
|