mirror of
https://github.com/goodtft/LCD-show.git
synced 2024-12-11 20:24:16 +01:00
27 lines
895 B
C
27 lines
895 B
C
|
#pragma once
|
||
|
|
|
||
|
|
// Data specific to the Waveshare35b display
|
||
|
|
#ifdef WAVESHARE35B_ILI9486
|
||
|
|
|
||
|
|
// SPI_BUS_CLOCK_DIVISOR specifies how fast to communicate the SPI bus at. Possible values
|
||
|
|
// are 4, 6, 8, 10, 12, ... Smaller values are faster. On my Waveshare35b display, the
|
||
|
|
// following values were observed to work (on a Pi 3B):
|
||
|
|
|
||
|
|
// core_freq=400: CDIV=14, results in 28.57MHz
|
||
|
|
// core_freq=255: CDIV=8, results in 31.875MHz
|
||
|
|
|
||
|
|
// While the following values were seen to not work:
|
||
|
|
|
||
|
|
// core_freq=400: CDIV=12, would result in 33.33MHz, but this was too fast for the display
|
||
|
|
// core_freq=256: CDIV=8, would result in 32.00MHz, this would work 99% of the time, but occassionally every ~few minutes would glitch a pixel or two
|
||
|
|
|
||
|
|
#if !defined(GPIO_TFT_DATA_CONTROL)
|
||
|
|
#define GPIO_TFT_DATA_CONTROL 24
|
||
|
|
#endif
|
||
|
|
|
||
|
|
#if !defined(GPIO_TFT_RESET_PIN)
|
||
|
|
#define GPIO_TFT_RESET_PIN 25
|
||
|
|
#endif
|
||
|
|
|
||
|
|
#endif
|