From 564dce2c35ca5a939bc185f43c67fdb38651681b Mon Sep 17 00:00:00 2001 From: goodtft Date: Fri, 30 Mar 2018 14:30:03 +0800 Subject: [PATCH] Delete config-35-960X640.txt --- boot/config-35-960X640.txt | 64 -------------------------------------- 1 file changed, 64 deletions(-) delete mode 100644 boot/config-35-960X640.txt diff --git a/boot/config-35-960X640.txt b/boot/config-35-960X640.txt deleted file mode 100644 index 6d12812..0000000 --- a/boot/config-35-960X640.txt +++ /dev/null @@ -1,64 +0,0 @@ -# For more options and information see -# http://www.raspberrypi.org/documentation/configuration/config-txt.md -# Some settings may impact device functionality. See link above for details - -# uncomment if you get no picture on HDMI for a default "safe" mode -#hdmi_safe=1 - -# uncomment this if your display has a black border of unused pixels visible -# and your display can output without overscan -#disable_overscan=1 - -# uncomment the following to adjust overscan. Use positive numbers if console -# goes off screen, and negative if there is too much border -#overscan_left=16 -#overscan_right=16 -#overscan_top=16 -#overscan_bottom=16 - -# uncomment to force a console size. By default it will be display's size minus -# overscan. -#framebuffer_width=1280 -#framebuffer_height=720 - -# uncomment if hdmi display is not detected and composite is being output -hdmi_force_hotplug=1 - -# uncomment to force a specific HDMI mode (this will force VGA) -#hdmi_group=1 -#hdmi_mode=1 - -# uncomment to force a HDMI mode rather than DVI. This can make audio work in -# DMT (computer monitor) modes -#hdmi_drive=2 - -# uncomment to increase signal to HDMI, if you have interference, blanking, or -# no display -#config_hdmi_boost=4 - -# uncomment for composite PAL -#sdtv_mode=2 - -#uncomment to overclock the arm. 700 MHz is the default. -#arm_freq=800 - -# Uncomment some or all of these to enable the optional hardware interfaces -dtparam=i2c_arm=on -#dtparam=i2s=on -dtparam=spi=on -enable_uart=1 -# Uncomment this to enable the lirc-rpi module -#dtoverlay=lirc-rpi - -# Additional overlays and parameters are documented /boot/overlays/README - -# Enable audio (loads snd_bcm2835) -dtparam=audio=on -hdmi_force_hotplug=1 -config_hdmi_boost=7 -hdmi_drive=2 -hdmi_force_hotplug=1 -hdmi_group=2 -hdmi_mode=87 -hdmi_cvt 960 640 60 6 0 0 0 -dtoverlay=ads7846,cs=1,penirq=25,penirq_pull=2,speed=50000,keep_vref_on=0,swapxy=0,pmax=255,xohms=150,xmin=200,xmax=3900,ymin=200,ymax=3900