15 Commits

Author	SHA1	Message	Date
James Cotton	93c44f2a4e	RM2 Temporary patch: Swap the GPIO pins and the VSense pins. This needs to be based on the hardware revision later.	2012-09-26 03:02:25 -05:00
James Cotton	dadc38d82d	Revo Mini 2: Get basic LED working. Board revision is actually 3 since right now it masquerades as Revo.	2012-09-26 01:17:32 -05:00
James Cotton	68fa464ccf	RM: Make the direction of the TX/RX lines come from the configuration file	2012-09-04 23:22:56 -05:00
James Cotton	a33f415866	RM DSM: Get DSM working on the mainport ... Because of the inverter this does not support binding on this port.	2012-08-31 11:08:43 -05:00
James Cotton	300cee44b4	RM SBUS: There is no pull down on the inverter direction so when not SBUS must explicitly set to off.	2012-08-31 11:01:34 -05:00
James Cotton	d333e24a43	RM: Swap to using the CC_ flags for the flexi port too.	2012-08-31 10:30:00 -05:00
James Cotton	27c46c78b2	Increase the RFM22b/Flash rate to 10MHz which is within tolerance for both.	2012-08-25 23:17:53 -05:00
James Cotton	4014445cc9	Fix the IRQ line for the RFM22b	2012-08-25 19:10:16 -05:00
James Cotton	9e25e887c2	Temporarily disable flash chip and configure SPI for modem.	2012-08-25 18:43:13 -05:00
James Cotton	ad7a9b9cc3	Switch the order of the SET_RC pins for flash and rfm22b	2012-08-25 17:49:15 -05:00
James Cotton	76bdb190d8	Link in the rfm module to the target	2012-08-25 17:27:17 -05:00
James Cotton	2edc976168	Fix the VBUS sense pin	2012-08-25 13:46:55 -05:00
James Cotton	ce5ef7edf3	Update the serial ports and receiver and servo ports	2012-08-25 13:19:23 -05:00
James Cotton	05e2e24bcb	Reconfigure the SPI ports.	2012-08-25 12:38:44 -05:00
James Cotton	60160001c6	Copy the revo project to revo mini	2012-08-25 12:23:54 -05:00