1
0
mirror of https://bitbucket.org/librepilot/librepilot.git synced 2024-12-10 18:24:11 +01:00
Commit Graph

17 Commits

Author SHA1 Message Date
James Cotton
879dfed288 RM2/RM1: Make the firmware and bootloader support the pin mappings between these two targets
for USB and radio

A side-effect of this is the pipxsettings are no longer populated into the rfm22b cfg structure
as that was made constant to be consistent with other drivers.
2012-10-02 09:31:15 -05:00
a*morale
c2910d0ce0 Receiver input working for both PPM/PWM mode for rm2 2012-09-30 20:54:10 +02:00
James Cotton
93c44f2a4e RM2 Temporary patch: Swap the GPIO pins and the VSense pins. This needs to be based on the hardware revision later. 2012-09-26 03:02:25 -05:00
James Cotton
dadc38d82d Revo Mini 2: Get basic LED working. Board revision is actually 3 since right now it masquerades as Revo. 2012-09-26 01:17:32 -05:00
James Cotton
68fa464ccf RM: Make the direction of the TX/RX lines come from the configuration file 2012-09-04 23:22:56 -05:00
James Cotton
a33f415866 RM DSM: Get DSM working on the mainport
Because of the inverter this does not support binding on this port.
2012-08-31 11:08:43 -05:00
James Cotton
300cee44b4 RM SBUS: There is no pull down on the inverter direction so when not SBUS must explicitly set to off. 2012-08-31 11:01:34 -05:00
James Cotton
d333e24a43 RM: Swap to using the CC_ flags for the flexi port too. 2012-08-31 10:30:00 -05:00
James Cotton
27c46c78b2 Increase the RFM22b/Flash rate to 10MHz which is within tolerance for both. 2012-08-25 23:17:53 -05:00
James Cotton
4014445cc9 Fix the IRQ line for the RFM22b 2012-08-25 19:10:16 -05:00
James Cotton
9e25e887c2 Temporarily disable flash chip and configure SPI for modem. 2012-08-25 18:43:13 -05:00
James Cotton
ad7a9b9cc3 Switch the order of the SET_RC pins for flash and rfm22b 2012-08-25 17:49:15 -05:00
James Cotton
76bdb190d8 Link in the rfm module to the target 2012-08-25 17:27:17 -05:00
James Cotton
2edc976168 Fix the VBUS sense pin 2012-08-25 13:46:55 -05:00
James Cotton
ce5ef7edf3 Update the serial ports and receiver and servo ports 2012-08-25 13:19:23 -05:00
James Cotton
05e2e24bcb Reconfigure the SPI ports. 2012-08-25 12:38:44 -05:00
James Cotton
60160001c6 Copy the revo project to revo mini 2012-08-25 12:23:54 -05:00