James Cotton
88b483f37d
PIOS_MPU6000: Make the driver perform the rotation to bring it into the OP
...
coordinate system
Previously there were hacks spread throughout to deal with various ways of
positioning the chips. Now the driver structure specifies the rotation
of the chip relative to the board layout and the output X/Y/Z are already
in OP convention.
This flag seems to do the right thing for Revolution, CC3D, and RevoMini
2012-09-11 01:46:22 -05:00
James Cotton
0d3b0d4e5b
Fixup: Disable binding on mainport for DSM
2012-09-01 11:11:28 -05:00
James Cotton
a33f415866
RM DSM: Get DSM working on the mainport
...
Because of the inverter this does not support binding on this port.
2012-08-31 11:08:43 -05:00
James Cotton
300cee44b4
RM SBUS: There is no pull down on the inverter direction so when not SBUS must explicitly set to off.
2012-08-31 11:01:34 -05:00
James Cotton
d333e24a43
RM: Swap to using the CC_ flags for the flexi port too.
2012-08-31 10:30:00 -05:00
James Cotton
73c7190077
RM GPS: Use the CC_MainPort instead of a RV flag and enable GPS support
2012-08-31 10:17:10 -05:00
James Cotton
bdd50ce66b
Reenable the flash system
2012-08-26 05:03:05 -05:00
James Cotton
9e25e887c2
Temporarily disable flash chip and configure SPI for modem.
2012-08-25 18:43:13 -05:00
James Cotton
ad7a9b9cc3
Switch the order of the SET_RC pins for flash and rfm22b
2012-08-25 17:49:15 -05:00
James Cotton
76bdb190d8
Link in the rfm module to the target
2012-08-25 17:27:17 -05:00
James Cotton
31ebb7bbd8
Remove the old BMA180 and L3GD20 code and fix the irq lines for the sensors.
2012-08-25 13:51:52 -05:00
James Cotton
ce5ef7edf3
Update the serial ports and receiver and servo ports
2012-08-25 13:19:23 -05:00
James Cotton
05e2e24bcb
Reconfigure the SPI ports.
2012-08-25 12:38:44 -05:00
James Cotton
60160001c6
Copy the revo project to revo mini
2012-08-25 12:23:54 -05:00
