The gdb init files would previously reset the target immediately
when gdb started up. This is sometimes an unpleasant side-effect
of running gdb.
In order to connect to the target, use the new "connect" function.
To reset the target use "mon reset".
git-svn-id: svn://svn.openpilot.org/OpenPilot/trunk@1236 ebee16cc-31ac-478f-84a7-5cbb03baadba
This fixes the gdb stepi command to allow the M3 core to make
forward progress even when interrupts are pending. M3 Core interrupts
are masked/unmasked in pre and post command hooks.
git-svn-id: svn://svn.openpilot.org/OpenPilot/trunk@636 ebee16cc-31ac-478f-84a7-5cbb03baadba
The gdb commands step, next and finish on the M3 core would
never make forward progress since there is almost always an
interrupt pending. This is a known problem on the M3, and is
fixed by adding pre and post command hooks which mask and unmask
all ISRs on the M3 core.
Step, next and finish now work as expected, but care should be
taken when using these commands across any part of the code that
actually _needs_ the interrupts in order to make forward progress.
git-svn-id: svn://svn.openpilot.org/OpenPilot/trunk@622 ebee16cc-31ac-478f-84a7-5cbb03baadba
