CC and CC3D boards share the same FW image. This is accomplished
by checking the BOARD_REVISION field in the board_info_blob
that is stored in the BL partition in flash as we init the FW.
Make sure that the BU image only writes a BL image that has
the same BOARD_TYPE and BOARD_REVISION fields in the embedded
image as the ones currently in flash on the board.
This ensures that we never write a CC3D BL image onto a CC board
and vice versa. This check should prevent "bricking" a board.
Bootloader updaters were all broken due to recent
changes in LED configuration handling. Removing
LED support from the BU loads allows them to build
again, but they provide no feedback about when they're
finished writing flash.
New targets:
- make blupd_all_clean
- make blupd_all
- make blupd_openpilot
- make blupd_ahrs
- make blupd_coptercontrol
- make blupd_pipxtreme
These targets are also included in the 'all_flight' target.
Led(LED1 different color on each board) Sequence:
1-Power On
2-Led ON for 3 seconds (you can disconnect during this time - safety measure)
3-Led flashes very quickly while the board is being programed (because the program is stored in memory this is very fast and looks like a led glitch)
4-If all good - LED flashes 3 times with a 1sec period and turns off - you may now reboot.
4-If an error ocurred - LED will keep flashing with a 500ms period until power off
git-svn-id: svn://svn.openpilot.org/OpenPilot/trunk@2804 ebee16cc-31ac-478f-84a7-5cbb03baadba
