InputWidget 0 0 626 532 Form 0 RC Input 1 Start Configuration Wizard Run Calibration Qt::Vertical 20 40 0 0 0 70 TextLabel true Back Next Cancel Flight Mode Switch Settings 310 10 201 17 75 true Warning: avoid "Manual" 310 30 201 17 75 true for multirotors! 30 130 445 155 Configure each stabilization mode for each axis Roll Qt::AlignBottom|Qt::AlignHCenter Pitch Qt::AlignBottom|Qt::AlignHCenter Yaw Qt::AlignBottom|Qt::AlignHCenter Stabilized1 Qt::AlignCenter Stabilized2 Qt::AlignCenter Stabilized3 Qt::AlignCenter 30 0 261 121 FlightMode Switch Positions 100 55 151 26 100 25 151 26 Select the stabilization mode on this position (manual/stabilized/auto) 10 30 62 17 Pos. 3 100 85 151 26 10 60 62 17 Pos. 2 10 90 62 17 Pos. 1 false 70 30 20 81 This slider moves when you move the flight mode switch on your remote. Setup the flightmode channel on the RC Input tab if you have not done so already. -100 100 10 -100 Qt::Vertical QSlider::TicksBelow 100 Arming Settings 50 false Arm airframe using throttle off and: Indicate the control used for arming the airframe, in addition to setting the throttle to its minimum position. In other terms "Throttle Off". Qt::Horizontal 40 20 Arming timeout: After the time indicated here, the frame go back to disarmed state. 64 seconds. Qt::Horizontal 40 20 Airframe disarm is done by throttle off and opposite of above combination. Qt::Vertical 20 40 Qt::Horizontal 40 20 0 0 32 32 :/core/images/helpicon.svg:/core/images/helpicon.svg 32 32 true Send to OpenPilot but don't write in SD. Be sure to set the Neutral position on all sliders before sending! Apply Be sure to set the Neutral position on all sliders before sending! Applies and Saves all settings to SD Save fmsSlider fmsModePos3 fmsSsPos3Roll fmsSsPos3Pitch fmsSsPos3Yaw fmsModePos2 fmsSsPos2Roll fmsSsPos2Pitch fmsSsPos2Yaw fmsModePos1 fmsSsPos1Roll fmsSsPos1Pitch fmsSsPos1Yaw