Here is a list of some known unresolved issues. If an issue has JIRA ID [OP-XXX], you may track it using the following URL: http://bugs.openpilot.org/browse/OP-XXX + Missing Translations, use English. + Radio Wizard confused by a reversed throttle, fix it on your transmitter before starting wizard. + Radio Wizard Throttle display does not show full range properly. + [Windows 8] USB Driver is broken. + Firmware Update Instructions on Firmware Tab not entirely accurate for all upgrade paths. + Tricopter's using Vehicle Wizard need to check servo does not need reversed manually. + XAircraft ESCs uses non-standard PPM range which may cause issues with Vehicle Wizard. + Spectrum Satellite Receivers setup in Radio Wizard may have wrong protocol set. + Old Intel 965 have an OpenGL bug that turns the QML PFD black and while. + [OP-732] Import UAV Settings for inactive modules crashes the running firmware (board restarts). Workaround: update firmware, power cycle, enable modules, power cycle, import configuration. + [OP-747] Board infinitely reboots itself after firmware upgrade (settings erase firmware is a workaround). + [OP-723] GCS uses the system language ot the 1st run. After restart it uses English (can be changed later). + [OP-725] GCS camera stab config error message disappears too fast (but config error is cleared as it should) + [OP-767] GCS does not send AttitudeActual packets over serial port when GPS is connected and system is armed + [OP-768] GCS does not show UAV position on the map (master or next CC branches, but works in Revo branches) + [OP-682] GCS crashes on firmware page. Noted on Windows and OSX platforms, difficult to reproduce. Workaround: use Vehicle setup wizard to update the firmware.