InputWizardWidget
0
0
644
529
-
0
-
0
0
Welcome to the inputs configuration wizard.
Please follow the instructions on the screen and only move your controls when asked to.
Make sure you already configured your hardware settings on the proper tab and restarted your board.
You can press 'back' at any time to return to the previous screen or press 'Cancel' to quit the wizard.
Qt::AutoText
true
-
Please choose your transmitter type:
true
-
Acro: normal transmitter for fixed-wing or quad
-
Surface: has reversible motor controlled by throttle stick, plus yaw control (2 channels)
-
Helicopter: has collective pitch and throttle input
-
<html><head/><body><p>If selecting the Helicopter option, please engage throttle hold now.</p><p>If selecting the Surface option, the <b>Flight Mode Count</b> will be set to be 1.</p></body></html>
true
-
Qt::Vertical
20
23
-
Please choose your transmitter mode:
true
-
Mode 1
-
Mode 2
-
Mode 3
-
Mode 4
-
For a Quad: Elevator is Pitch, Ailerons are Roll, and Rudder is Yaw.
true
-
Identify sticks instructions
true
-
Please center all controls and trims and press Next when ready.
If your FlightMode switch has only two positions, leave it in either position.
true
-
Please move all controls to their maximum extents on both directions.
Press Next when ready.
true
-
-
Please check the picture below and correct all the sticks which show an inverted movement. Press Next when ready.
true
-
You have completed this wizard, please check below if the picture mimics your sticks movement.
IMPORTANT: These new settings have not been saved to the board yet. After pressing Next you will go to the Arming Settings tab where you can set your desired arming sequence and save the configuration.
true
-
0
1
-
-
Back
-
Next
-
Cancel