OutputWidget 0 0 659 523 Form QFrame::StyledPanel QFrame::Raised 1 1 1 3 2 false Setup "TurboPWM" here: usual value is 400 Hz for multirotor airframes. Leave at 50Hz for fixed wing. 400 - Qt::AlignCenter - Qt::AlignCenter - Qt::AlignCenter false Setup "TurboPWM" here: usual value is 400 Hz for multirotor airframes. Leave at 50Hz for fixed wing. 400 false Setup "TurboPWM" here: usual value is 400 Hz for multirotor airframes. Leave at 50Hz for fixed wing. 400 false Setup "TurboPWM" here: usual value is 400 Hz for multirotor airframes. Leave at 50Hz for fixed wing. 400 - Qt::AlignCenter Qt::Horizontal QSizePolicy::Minimum 40 20 75 true Channel: Qt::AlignRight|Qt::AlignTrailing|Qt::AlignVCenter Qt::Horizontal QSizePolicy::Minimum 40 20 75 true Update rate: Qt::AlignRight|Qt::AlignTrailing|Qt::AlignVCenter Qt::Vertical 20 40 Motors spin at neutral output when armed and throttle below zero (be careful) Qt::Horizontal 40 20 Qt::Vertical 20 40 true Move the servos using the sliders. Two important things: - Take extra care if the output is connected to an motor controller! - Will only work if the RC receiver is working (failsafe) Test outputs Qt::Horizontal 40 20 0 0 32 32 :/core/images/helpicon.svg:/core/images/helpicon.svg 32 32 true Send to OpenPilot but don't write in SD. Be sure to set the Neutral position on all sliders before sending! Apply Be sure to set the Neutral position on all sliders before sending! Applies and Saves all settings to SD Save outputRate1 outputRate2 outputRate3 outputRate4 channelOutTest saveRCOutputToRAM saveRCOutputToSD