Vladimir Zidar
50fce728f8
LP-479 Addressed PR comments
2017-04-25 14:10:08 +02:00
Vladimir Zidar
1ebfb701f6
LP-479 Initial DShot implementation, F4 & F1
2017-04-25 14:10:07 +02:00
Alessio Morale
7ed8e63689
LP-385 - Fix Actuator support for CameraControl
2016-08-29 19:57:55 +02:00
Alessio Morale
22969c5e17
LP-385 - Implement camera trigger output handling
2016-08-18 12:10:14 +02:00
Laurent Lalanne
214ae849a2
LP-233 Add MultiShot 5 - 25µs pulses
2016-05-02 20:24:03 +02:00
Laurent Lalanne
2bda2e2901
LP-233 Simplify, same clock used for all OneShot modes
2016-05-02 20:24:03 +02:00
Laurent Lalanne
78be10ff28
LP-233 Multiply / factor instead of scale
2016-05-02 20:24:03 +02:00
Laurent Lalanne
49107e4007
LP-233 Increase Oneshot output resolution
2016-05-02 20:24:03 +02:00
Laurent Lalanne
32a6de6b79
LP-233 Support OneShot42
2016-05-02 20:24:03 +02:00
Laurent Lalanne
3f344bde4d
LP-228 Treat Gimbal outputs only if CamStab module is enabled.
2016-03-16 15:58:38 +01:00
Laurent Lalanne
406c381071
LP-206 Add Always stabilized accessory switch - Fix: Allow Accessory3 for arming
2016-03-07 18:26:10 +01:00
Stefan Karlsson
51f0b74e5c
LP-129 Remove broken motor scaling modes
2015-09-24 23:02:09 +02:00
Stefan Karlsson
2ab6390cf5
LP-128 Fix scaleMotor attitude problems
...
The ElevateAndCompress scaling mode doesn't scale linearly as intended
and causes motors to reach the max limit prematurely.
A new mode, MoveAndCompress, has been implemented to get better linear
scaling of the motor output values.
2015-09-22 21:25:56 +02:00
Alessio Morale
bc89c79b7d
Merged in skarlsso/librepilot/skarlsso/LP-107_scaleMotor_bug (pull request #46 )
...
skarlsso/lp 107_scalemotor_bug
2015-09-08 15:27:51 +02:00
a*morale
792835c009
Uncrustify
2015-09-05 11:49:43 +02:00
Stefan Karlsson
71f6e82399
LP-107 Use scaleChannel for unscaled motor outputs
2015-09-01 21:17:52 +02:00
Stefan Karlsson
f7b8a57e42
LP-107 Replace the scaling function in scaleMotors
...
The previous scaling function used in scaleMotor could end up with
output values below the neutral point.
This patch adds a new scaling mode that will try to scale the output
proportionally while still keep all outputs within neutral and max.
The user can select three different modes:
1) NoScaling - Only cap the output values between neutral and max.
2) AddAndSubtract - The previous output scaling method, which moves the
output values directly proportionally to the amount the max/min motor
is out of the limits.
3) ElevateAndCompress - The new mode, which elevates all motor values by
the percentage needed to bring the min motor to neutral, and then
compress all motor values by the percentage needed to bring the max
motor down to max.
The motor scaling mode can be selected by setting the
FlightModeSettings.MotorScalingMode UAVO field.
2015-08-31 21:29:48 +02:00
Alessio Morale
538a137bf6
Merged in f5soh/librepilot/laurent/LP-92_Feed_forward_remove (pull request #33 )
...
Laurent/lp 92_feed_forward_remove
2015-08-21 13:35:10 +02:00
Roy Bekken
ad84547637
Update all changed files against GIT log with copyright headers consistency.
2015-08-19 16:15:58 +02:00
Laurent Lalanne
670dbfe9ce
LP-92 Remove Feed Forward : flight / ground
2015-08-14 10:54:12 +02:00
Laurent Lalanne
31c30d752f
LP-66 Fixed wing : Roll differential mixing on flight side
2015-07-29 06:36:22 +02:00
Alessio Morale
c227686854
uncrustify
2015-05-02 20:27:28 +02:00
RS2K
2fca0b1d9b
OP-1835 - Motor Constraints for 15.02.02 - Quick fix to disable clipping. Bit of code not in the original fix I had to deal with.
2015-05-02 13:11:40 -05:00
RS2K
57d062ff67
OP-1835 - Motor Constraints for 15.02.02
...
OP-1835 - Motor Constraints for 15.02.02
2015-05-02 12:55:43 -05:00
abeck70
5c9b6fac29
OP-1769 uncrustify
2015-03-14 12:15:59 +11:00
abeck70
5e7a3c30e1
OP-1769 ground actuator
...
code review comment addressed to reduce code size
2015-03-14 12:01:30 +11:00
abeck70
dd2733d73f
OP-1769 Ground support review comments
2015-03-11 13:49:21 +11:00
abeck70
f053954228
OP-1769 CC compile fixes
2015-03-10 23:07:14 +11:00
abeck70
52147333ed
OP-1769 Ground Support
...
1. Receiver.c for ground allows disabled channels for all but yaw and throttle
2. Reciever.c applies a deadband on throttle 0 position
3. Arming understands ground have a 0 throttle position
4. Actuator optimisations in general and fixes for mixing
5. Actuator mixer support for reversible motors
2015-03-10 22:54:51 +11:00
Alessio Morale
1f5f5747f7
OP-1685 - Fix glitches on output settings save. It was due to wrong check for bankmode changes.
2015-02-22 14:21:23 +01:00
Alessio Morale
2a90e86e58
OP-1685 - Try to avoid unneded updates to prevent output glitches
2015-02-22 13:12:00 +01:00
Alessio Morale
39513f0533
OP-1685 - Rename OneShot to PWMSync to avoid confusion
2015-02-17 23:20:07 +01:00
Alessio Morale
752f3447d2
OP-1683 - Implement an update skip strategy in single pulse mode when pulse period is higher than the update cycle
2015-02-02 02:58:22 +01:00
Alessio Morale
1d08083375
OP-1682 - OneShot125: Change timer clock to 2MHz (that's available as exact value for current targets), raise timer period to prevent glitches
2015-01-31 14:40:40 +01:00
Alessio Morale
632051c0ac
OP-1683 - Increase resolution for OneShot125 running timer at 8MHz, setup automatically rates for OneShot
2015-01-30 21:22:00 +01:00
Alessio Morale
7955f63c98
OP-1683 - Clenaup, trigger update in setfailsafe, Fix standard pwm operation
2015-01-25 21:25:14 +01:00
Alessio Morale
dcc9a5b7dc
OP-1683 - Actuator uses "standard" 1000-2000 range and remap it to 125-250 just before sending to servo to prevent any impact on gcs and other blocks
2015-01-24 13:37:00 +01:00
Alessio Morale
47e1312982
OP-1683 - Implement oneshot/oneshot125 mode to actuator module
2015-01-23 23:51:53 +01:00
Alessio Morale
263fd64ab5
Merge branch 'amorale/OP-1274_freertos_v8.0.0' into next
2014-06-22 16:06:21 +02:00
Alessio Morale
eb5deb3eca
OP-1274 Remove unneeded cast from task name in xTaskCreate call
2014-06-18 01:47:43 +02:00
Alessio Morale
8710ff4070
OP-1227 Fix high CPU usage: Some minor to Actuator module.
2014-06-08 22:39:16 +02:00
Alessio Morale
be5cc66bd3
OP-1274 fixes for Coptercontrol firmware
2014-05-18 22:56:29 +02:00
Corvus Corax
0ece1a1fb3
OP-1216 removed "reverseThrottle" systemsetting and have reversethrottle implicitly allowed for REVERSABLEMOTOR type outputs
2014-03-09 10:00:58 +01:00
Corvus Corax
148b453aad
OP-1216 added new mixer output type "reversable motor" to have engines which can can backwards go to a safe level when disarmed
2014-03-09 01:37:22 +01:00
Corvus Corax
dbbb8d5e0d
OP-1216 fixes as suggested in OPReview-645
2014-03-03 18:58:09 +01:00
Corvus Corax
2f57ea2ab3
added missing initializations to allow boot without manualcontrol module
2014-03-02 19:00:37 +01:00
Corvus Corax
f61231f610
OP-1216 moved safety zeroing for channels from Stabilization to Actuators (so it also affects manual mode)
2014-03-02 15:35:39 +01:00
Corvus Corax
37ef381f8d
OP-1216 clamping of throttle to -1 in actuators (optional)
2014-02-16 12:27:01 +01:00
Corvus Corax
b5a27d05e7
OP-1197 configurable failsafes OP-1219 thrust control OP-1217 separate manualcontrolsettings apart
2014-02-09 19:37:22 +01:00
Corvus Corax
8b25ac1894
OP-1195 adapted task priorities for manualcontrol and stabilization
2014-02-02 14:13:25 +01:00
