Zach Eveland
09aa8bd678
reduced Caterina timeout to 8 seconds from 16
2012-03-01 08:51:47 -05:00
Zach Eveland
4c3aa52258
Leonardo now checks whether bootloader should be run after a WDT event.
...
Before the sketch initiates an auto-reset for upload it pokes a magic word into a specific RAM address. On starting the bootloader checks this address. If it finds the magic word it knows the bootloader code should run. If not it jumps straight back to sketch.
Test in a sketch by adding to setup():
wdt_enable(WDTO_2S);
Sketch should upload, start, run for two seconds, WDT, and sketch should restart (not bootloader).
Had to cut out unused descriptor code to make the bootloader still fit in 4k.
2012-02-14 12:17:30 -05:00
Zach Eveland
52b0c7214b
Leonardo bootloader jumps straight to sketch for a power-on reset.
...
Disconnect programmer after burning bootloader to get the full effect. ICSP and JTAG programmers do a hardware reset after any reset condition, confusing the firmware a little.
2012-02-14 09:59:48 -05:00
Zach Eveland
25a4fe8607
changed Leonardo bootloader and sketch PID values again (now 0x0701 for bootloader, 0x0801 for sketch)
2012-02-13 00:10:16 -05:00
Zach Eveland
c39793001c
adjusting descriptors - trying to prevent sketch and bootloader from grabbing different COM numbers on Windows
2012-02-08 01:16:56 -05:00
Zach Eveland
4ee57f12e9
changed Caterina descriptors - Arduino LLC VID, new PID, manufacturer string, and serial number
2012-02-07 23:52:55 -05:00
Zach Eveland
5d53eed01a
fixed bug in Caterina which caused some programming instructions to fail
...
Timer 1 interrupts were trashing self-programming timing. Now disable Timer 1 compare match before doing Flash tasks and reenable afterward.
2012-02-07 23:46:31 -05:00
Zach Eveland
f2d5ea87ad
increased Leonardo bootloader timeout to 16 seconds
2012-02-06 15:23:41 -05:00
Zach Eveland
5483adf8fe
proper bootloader timeout and LED control in Leonardo bootloader
2012-02-03 23:15:04 -05:00
Zach Eveland
1303b6fbba
Caterina now cleanly hands off operation to the sketch
...
had to remove TIMER1 operation from bootloader - was interfering with normal sketch operation
2012-01-24 18:04:10 -05:00
Zach Eveland
6498b66059
move interrupt vector table to application section before jumping to it after upload finished.
2012-01-21 16:51:55 -05:00
Zach Eveland
73f6f2edd5
Leonardo bootloader checks reason for reset and jumps immediately to sketch if reset was caused by WDT
2012-01-21 16:39:06 -05:00
Zach Eveland
371b72c681
stripped all LUFA LED control. from LUFA-based Caterina
2012-01-19 21:31:51 -05:00
Zach Eveland
db397d5b35
added Board/LEDs.h to LUFA-based Caterina
2012-01-19 21:17:12 -05:00
Zach Eveland
98b0491fbd
superficial changes to stock LUFA CDC bootloader - renamed project, removed unnecessary files
2012-01-19 20:31:35 -05:00
