1
0
mirror of https://bitbucket.org/librepilot/librepilot.git synced 2024-12-11 19:24:10 +01:00
Commit Graph

85 Commits

Author SHA1 Message Date
Laurent Lalanne
9e3d464523 Merge branch 'master' into translations_next
Conflicts:
	ground/openpilotgcs/copydata.pro
	ground/openpilotgcs/share/openpilotgcs/translations/openpilotgcs_fr.ts
2013-10-25 11:27:28 +02:00
Mathieu Rondonneau
03b243fe31 OP-1079 - Update to FreeRTOS v7.5.2 2013-09-04 20:26:23 -07:00
Brian Webb
e246ecf536 Moves pios_led functionality to pios_gpio and makes pios_led a thin layer over pios_gpio. Supports configuring multiple sets of GPIOs. 2013-07-28 07:01:08 -07:00
Richard Flay (Hyper)
c3e3521001 OP-1049: Hotfix to 13.06.02 for MPU6000 FIFO overflow on CC3D when board initialisation takes
longer than 150ms.
2013-07-28 01:16:22 +09:30
Brian Webb
0d02df4d02 Uncrustified OPLink code. 2013-07-05 18:49:26 -07:00
Brian Webb
d0d8a0aadd OP-932 Adds PWM outputs to OPLinkMini. Both gpio pins on the main and/or flexi port can be configured to output PWM for a total of up to 4 PWM outputs. 2013-07-03 18:58:34 -07:00
Brian Webb
c76ee7de9d OP-932 Fixes the failsafe that detects when the Rx modem loses sync with the Tx modem. This was not working on one-way mode. 2013-06-30 16:08:50 -07:00
Brian Webb
491e5fe685 Adds a failsafe on PPM output on OPLink that kicks in when the link goes down. Also updates all air datarate settings and adds new 64 and 100 kbps modes. 2013-06-29 15:00:38 -07:00
Brian Webb
d5f16faaec OP-932 Fixes the datarate used on PPM only mode, and fixes failsafe on PPM output on OPLM. 2013-06-26 20:11:39 -07:00
Brian Webb
caa8d3e70e OP-932 Forces one-way to be set when PPM only is configured. 2013-06-26 18:02:08 -07:00
Brian Webb
2aea2342ab OP-932 Adds a direct PPM channel on each Tx packet when in PPM mode, and adds a PPM only mode that uses a 9600 bps air datarate. Also updates the OPLink configuration tab and moves all OPLink configuration to the OPLink configuration tab on the Revo, and customizes the OPLink configuration tab for the Revo. 2013-06-26 18:01:54 -07:00
Brian Webb
44a0266e41 OP-932 Adds claiming of the SPI bus in the OPLink channel change function. 2013-06-26 18:00:02 -07:00
Brian Webb
56a60f2983 OP-932 Updates the 19.2 kbps datarate using the spreadsheet. 2013-06-26 17:59:49 -07:00
Brian Webb
61c453f6ff Removes several of the air datarate settings, and fine tunes the calculation of the max packet length from the datarate and packet time. 9600, 19200, 36400, and 57600 modes tested. Tested 19200 in one-way mode for PPM only. 2013-06-26 17:59:33 -07:00
Brian Webb
cdd51537f1 Fixes the 9600 bps air datarate for the RFM33B modem. 2013-06-26 17:57:46 -07:00
Brian Webb
fc0328a3cd OP-932 Adds working one-way mode to the OPLink radio connection. In this mode, packets will only flow from the ground side (coordinator modem) to the flight side modem. 2013-06-26 17:57:32 -07:00
Brian Webb
774a74884a OP-932 Replaces the RFM22B PPM/receiver code with an OPLinkReceiver UAVObject. This object is generated on a coordinator OPLink, and is used by both the OPLink to generate PPM output, and the OPLinkReceiver on the Revo. 2013-06-26 17:57:11 -07:00
Brian Webb
8c370df319 OP-932 A significant re-work of the OPLink and configuration of the OPLink. Auto-configuration is removed, and remote modems are bound the coordinator, rather than the other way around. Timing of the radio link is also significantly changed. The rfm22b code is also simplified so that it only sends packet, and has no notion about what those packets are, so the rfm22b is converteded to simply a com type device. 2013-06-26 17:56:56 -07:00
Brian Webb
08efc8d152 OP-932: Adds an oplink receiver device, which is based on the gcs receiver device, but uses the OPLinkReceiver UAVObject. The OPLinkReceiver packets are generated on the OPLink modem. 2013-06-26 17:56:20 -07:00
Brian Webb
7c10623615 OP-932 Adds a semaphore to PPM input to signal when a new frame has been received. This can be used to process a new frame with as low a latency as possible. 2013-06-26 17:56:10 -07:00
Alessio Morale
5cc3645b96 Uncrustify 2013-06-18 20:23:46 +02:00
Alessio Morale
e9b3ee52f3 OP-997: add fields to SystemStatsUavo to monitor storage status 2013-06-09 19:20:00 +02:00
Brian Webb
e9f83bcc80 Fixes a bug in the rfm22b driver that was reading past the end of the bindings list when receiving a status message. Also adds some formatting changes that came about after doing a make uncrustify_all. 2013-05-26 08:36:38 -07:00
Brian Webb
ac4847c8ac OP-932 Moves the configuration of the com ports on the coordinator OPLink to startup. 2013-05-21 19:48:21 -07:00
Brian Webb
dbce08a151 OP-932 Changes the radio task loop to loop every 1ms, and reduces the tx transmit period back down to 8ms. Also reduces the Tx windows to 1ms for each modem, and reserves the latter half of the Tx window for channel changing. 2013-05-21 17:40:05 -07:00
Brian Webb
d4a4588011 OP-932 Changes the RFM22 frequency hopping to change channels every Tx period. Also increases the Tx clock period from 8ms to 16ms, and adds a check on calculation the the time delta that it doesn't change the previous estimated time delta by too much. If the delta between the current time delta and the previously estimated time delta is too large it could indicate that there was a delay somewhere that makes the calculated time delta inaccurate.
Rearanges the packet send priority in the rfm22b driver so that PPM packets are top priority.
2013-05-20 20:49:24 -07:00
Sexy Pony
900f643bbd Reformat source code with 'make uncrustify_all' run twice. NO CODE CHANGES 2013-05-19 17:37:30 +03:00
Alessio Morale
ab7af16be3 Merge branch 'amorale/OP-901_lib_udates-usb_fixes' into HEAD
Conflicts:
	flight/pios/stm32f10x/library.mk
	flight/targets/boards/revoproto/firmware/pios_board.c
2013-05-19 15:01:08 +02:00
Alessio Morale
37eabb0931 Pointed type is explicitly used with sizeof when dealing with struct pointers.
+review OPReview-474
2013-05-19 12:00:16 +02:00
Alessio Morale
2e458b5652 OP-901 USB OTG/Device Drivers are not targeted for f103 (they are targeted at f105) so move again to F4 library folder instead of common 2013-05-18 20:53:28 +02:00
Alessio Morale
3ec9447fdc OP-901 Update CMSIS to r3p2-00rel1 2013-05-18 20:29:06 +02:00
Alessio Morale
c1f767b12d Merge remote-tracking branch 'origin/amorale/OP-954_logfs_settings_in_internal_flash' into next
Conflicts:
	flight/pios/common/pios_flashfs_logfs.c
2013-05-18 15:53:25 +02:00
Alessio Morale
66da2796e0 Merge remote-tracking branch 'origin/amorale/OP-905_revolution_watchdog_next' into next 2013-05-18 15:00:50 +02:00
Alessio Morale
976ad90211 OP-901 Updated F4 CMSIS startup files, Moved USB OTG and USB Device library to common 2013-05-18 14:03:03 +02:00
Alessio Morale
67e41c34fc Merge remote-tracking branch 'origin/next' into amorale/usb_fixes 2013-05-17 22:46:42 +02:00
Alessio Morale
2735f8a620 OP-901 Updated common CMSIS files 2013-05-17 22:41:34 +02:00
Richard Flay (Hyper)
ae14c13195 Merge branch 'next' into hyper/OP-951_add--Wshadow-to-flight-CFLAGS
Conflicts:
	flight/modules/ManualControl/manualcontrol.c
2013-05-16 06:28:56 +09:30
Richard Flay (Hyper)
ef5bb6f6fe Merge branch 'next' into OP-950_spi_fixes_FreeRTOS 2013-05-16 05:41:09 +09:30
Alessio Morale
707e648457 OP-905: Fixes. Prevent LogFS from triggering watchdog 2013-05-14 18:43:39 +02:00
Richard Flay (Hyper)
ed68fbe68d OP-951: Adds -Wshadow to flight CFLAGS and fixes resulting compilation breakage.
+review OPReview
2013-05-14 07:01:45 +09:30
Oleg Semyonov
e5970ed25d logfs: fix unit tests (requires MIN declaration from pios_math.h) 2013-05-12 03:51:00 +03:00
Stacey Sheldon
0d8fe83dca usb cdc: advertise support for line coding and serial state
The CDC descriptor was not advertising support the the line
coding and serial state messages.  This was preventing Mac
from sending the SetControlLineState message to indicate
that a DTE (ie terminal program) was present and reading
from the serial port.

We support (and depend on) the DTE indication now so this
was making CDC not work on Mac.

Linux seems to provide the indication regardless of whether
it is advertised in the descriptor or not.
2013-05-11 22:41:03 +02:00
Stacey Sheldon
b56f5206bd com/usart/cdc: ensure that device structs are memset before use
CDC and USART device drivers were not all clearing their
device structs before using them.

This specifically caused crashes in the case where the upper
COM layer was binding only a Tx path.  The Rx path callback
in the lower driver was uninitialized random data and would
result in the lower driver faulting when it tried to call the
callback.

Conflicts:
	flight/PiOS/STM32F30x/pios_usart.c
	flight/PiOS/STM32F30x/pios_usb_cdc.c
	flight/PiOS/STM32F30x/pios_usb_hid.c
2013-05-11 22:40:59 +02:00
Stacey Sheldon
e16be98224 usb cdc: ensure com buffer is drained when no DTE is attached
The CDC layer on F1, F3 and F4 now always acts like an
infinte data sink whenever *either* there is no DTE present
(ie. no terminal program listening) *or* the USB cable is
disconnected.

F1 and F4 were previously checking the cable but not the DTE.
F3 didn't check anything.  The COM layer didn't even ask the
lower layers.

All of this used to mean that any time a caller did a blocking
send to a CDC device without a DTE, it would eventually block
for up to a 5s timeout waiting for space in the Tx buffer.

Conflicts:
	flight/PiOS/STM32F30x/pios_usb_cdc.c
2013-05-11 22:40:58 +02:00
Richard Flay (Hyper)
04f59d5910 OP-950: Adds "higher priority task woken" logic to SPI and SPI bus resident
sensor device drivers. Based partly on code contributed by lilvinz.

+review OPReview
2013-05-11 16:18:34 +09:30
Werner Backes
7c9d2ce9a5 Merge branch 'D-Lite/OP-934_rfm22b_rcvr_timeout_handling_next' into next 2013-05-10 09:59:30 +02:00
Stacey Sheldon
8ab50bca13 flashfs: use uintptr_t instead of uint32_t in flashfs API 2013-05-08 19:42:01 +02:00
Stacey Sheldon
99e61dd617 logfs: support multiple instances of logfs
Conflicts:
	flight/pios/common/pios_flashfs_logfs.c
	flight/pios/inc/pios_flashfs_logfs_priv.h
	flight/tests/logfs/pios.h
	flight/tests/logfs/pios_config.h
	flight/tests/logfs/unittest.cpp
2013-05-08 19:28:11 +02:00
Werner Backes
938ed58918 Corrected timout calculation formula. 2013-05-06 14:20:53 +02:00
Werner Backes
bb87e6390e Update ppm_fresh if we receive a new PPM packet in order to keep the
rfm22b receiver supervisor happy.
2013-05-06 12:00:58 +02:00