1
0
mirror of https://bitbucket.org/librepilot/librepilot.git synced 2024-12-02 10:24:11 +01:00
Commit Graph

350 Commits

Author SHA1 Message Date
Karl Knutsson
9fd4fb26b9 OP-1532 fix non-ppm mode
Always send packets from the coordinator.
Previously the coordinator only always sent packets
on channel 0. This scheme doesn't work with
with the change to use 32 channel.
2014-10-08 20:59:51 +02:00
Fredrik Larsson
cb6e9fda6d Merge remote-tracking branch 'origin/havyan/oplink-0' into next 2014-10-08 08:02:48 +11:00
Karl Knutsson
4e365f6dff OP-1530 Use rfm22b_dev->num_channels
Use the number of allocated channel from the num_channels field
in the pios_rfm22b_dev struct rather than from the maximum number
of possible of channels given the configured speed.
2014-10-07 22:50:52 +02:00
Karl Knutsson
00d9c66867 OP-1522 Robustness of OPLink radio
Increase number of channels to 32 for all bit rates.
Synchronize clock on all channels.
Go into failsafe after 4 or 8 (one_way_link) missed packets.
Don't stay on channel 0 if we dropped a packet.
2014-10-03 22:20:11 +02:00
Karl Knutsson
1c6e9b3cc4 OP-1510 don't hard code tx_power to 100mW 2014-10-03 22:20:11 +02:00
Alessio Morale
8e2e534c60 Uncrustify/clean commented code 2014-10-03 11:41:26 +02:00
Alessio Morale
e553014596 Merge branch 'amorale/OP-1476_1477_1275_GPSV9_pios_firmware_bootloader' into next 2014-10-03 00:37:55 +02:00
Alessio Morale
9cfd55d006 Merge branch 'amorale/OP-1507_gps_module_cpu_optimization' into next 2014-10-03 00:37:39 +02:00
Alessio Morale
ae9f30c729 OP-1477 - Fix mag exti config, set correct rate, set correct SPI speed for hmc5x83. Note: GPIO is disabled as it seems there is some issues with Exti on PB0 2014-10-01 02:07:46 +02:00
Alessio Morale
0ffb99f228 OP-1477 - Fix issue with quick request to DDC port, change baud rate to 57600, fix sys rate, optimize uart tx 2014-10-01 02:06:03 +02:00
Alessio Morale
9e0596c2c5 Merge remote-tracking branch 'origin/amorale/OP-1379_ext_led_notification_module_new' into next
Conflicts:
	Makefile
	flight/targets/boards/discoveryf4bare/firmware/Makefile
	flight/targets/boards/revolution/firmware/Makefile
2014-09-29 21:26:31 +02:00
Alessio Morale
93cf6b457f OP-1507 - optimize com fifo usage when RX callback receives a single byte 2014-09-27 00:20:15 +02:00
Alessio Morale
7e789ccc69 OP-1379 - Clear output pin at the end of dma cycle 2014-09-25 00:59:39 +02:00
Alessio Morale
c772442723 OP-1477 - remove debug infos and add send some relevant informations using SYS message (firmware and board revision/info) 2014-09-24 01:06:41 +02:00
Alessio Morale
3c6a8e0395 OP-1379 - Prevent loosing any update to background notification and notifications with priority higher than current 2014-09-21 23:32:52 +02:00
Alessio Morale
7e73c59e90 OP-1476 - Fixes for Bootloader
- Allocate 10KBytes for bootloader;
- Replace pios_com_msg with pios_com for ssp support
- Change Speed to 9600 for higher reliability
2014-09-16 22:40:53 +02:00
Alessio Morale
f2a0daac5c OP-1477 - Add pios_ubx_ddc driver to handle i2c comms with UBlox GPS 2014-09-16 22:40:52 +02:00
Alessio Morale
81ae43ac40 OP-1275 - fix Watchdog 2014-09-16 22:40:50 +02:00
Alessio Morale
984a7a675c OP-1275 - add ChangeBaud to PIOS_COM_MSG 2014-09-16 00:42:51 +02:00
Alessio Morale
20273e77aa OP-1275 - Fix CPU usage due to uncleared irq flags 2014-09-16 00:42:51 +02:00
Alessio Morale
94c39caa50 OP-1275 - Fix PIOS_COM to be used with no PIOS_INCLUDE_FREERTOS defined 2014-09-16 00:42:51 +02:00
Alessio Morale
0c7f4905da OP-1275 - Fix PiOS_EXTI 2014-09-16 00:42:51 +02:00
Alessio Morale
de4180f990 OP-1275 - Reenable usart after init in ChangeBaud 2014-09-16 00:42:51 +02:00
Alessio Morale
212170bcb9 OP-1275 Fix pios_delay DiffuS 2014-09-16 00:42:51 +02:00
Alessio Morale
3c2300ffda OP-1275 Change several parameters const 2014-09-16 00:42:50 +02:00
Alessio Morale
0682e60053 OP-1275 Add a memory barrier before remapping the vector table 2014-09-16 00:42:50 +02:00
Alessio Morale
baad216810 OP-1275 uncrustification 2014-09-16 00:42:50 +02:00
Alessio Morale
55d52ceab0 OP-1275 Working initial PIOS_I2C implementation 2014-09-16 00:42:50 +02:00
Alessio Morale
cd7c76aa13 OP-1275 move implementation specific enums out of common pios_i2c_priv.h 2014-09-16 00:42:50 +02:00
Alessio Morale
5986e72a29 OP-1275 Add SPI Implementation. DMA block transfer needs to be fixed with handling for LDMA_TX and LDMA_RX 2014-09-16 00:42:49 +02:00
Alessio Morale
2ca1adafe5 OP-1275 support HSI oscillator, fix gpio, usart and sys (vector remapping not working yet) 2014-09-16 00:42:49 +02:00
Alessio Morale
7a3bc518c2 OP-1275 fixes unused vars in SPL 2014-09-16 00:42:49 +02:00
Alessio Morale
bb7d4aef04 OP-1275 fixes for ld scripts, fix for pios_delay timer setup. pios_sys 2014-09-16 00:42:49 +02:00
Alessio Morale
4d1e8cf5a7 OP-1275 F0 support: fix make scripts, bootloader size, linker scripts, add other missing pios drivers. 2014-09-16 00:42:49 +02:00
Alessio Morale
5ab9806279 OP-1275 add Stack_Change support 2014-09-16 00:42:48 +02:00
Alessio Morale
5a60c254ed OP-1275 copy relevant F1 PiOS drivers (yet unmodified) 2014-09-16 00:42:48 +02:00
Alessio Morale
7eca9f80e3 OP-1275 Initial commit for f0 support: add CMSIS, Std Peripheral drivers 2014-09-16 00:42:48 +02:00
Alessio Morale
b4c1a856c7 OP-1274 Implement 4 bytes aligment for standard malloc (while keeping 8byte alignment for RTOS Stuctures) as done for M3 2014-09-16 00:42:48 +02:00
Fredrik Larrson
d91db0af6f Revert "Merge remote-tracking branch 'origin/proff/OP-1373_DSMFixes' into next"
This reverts commit a39e393274, reversing
changes made to ebfdaf28b5.
2014-09-08 02:31:02 +10:00
Fredrik Larrson
a39e393274 Merge remote-tracking branch 'origin/proff/OP-1373_DSMFixes' into next
Conflicts:
	shared/uavobjectdefinition/hwsettings.xml
2014-09-08 01:54:59 +10:00
Fredrik Larrson
ebfdaf28b5 Merge remote-tracking branch 'origin/havyan/OP-1473_sbus_eof' into next 2014-09-08 01:35:39 +10:00
Alessio Morale
cf9329b8ee OP-1440 - Change timing slightly to support also WS2812B 2014-09-06 12:12:11 +02:00
Alessio Morale
233dec6d8d OP-1379 - Various fixes and additions
- Support blocks of led for notification (that is a certain number of leds between a min and a max index);
- Fix an issue with bogus colours on fast updates at LED N°0.
- Add NOTIFY_SEQUENCE_NULL to skip handling a specific alarm status;
- Adjust sequences and add Config and Receiver Alarms;
- fix issue with Alarm trigger/repetition;
- Enables Notify module only if a WS281x output is enabled.
- Add some documentation for sequence/alarm definitions (sequences.h)
- Make sequences more coherent. All GPS related info are now shown in green.
- Revert to original blinking rate for onboard led
- add Notify on DiscoveryF4Bare target
2014-09-06 12:11:53 +02:00
Karl Knutsson
ec0d44e1b0 OP-1473 Fix EOF handling for R7008SB 2014-09-04 18:15:36 +02:00
Corvus Corax
b64326208e Merge branch 'next' into corvuscorax/OP-1456_struct_to_array_improvement 2014-08-31 18:43:48 +02:00
Corvus Corax
6faf1a73ac OP-1456 get rid of cast_struct_to_array because it is error prone! 2014-08-24 00:16:34 +02:00
Stefan Karlsson
3d8d803c33 OP-922 Fix missing ppm_id to ppm_out_id rename 2014-08-16 16:58:16 +02:00
Stefan Karlsson
34983a2d28 OP-922 Fix typo in pios_tim.c 2014-08-16 16:58:15 +02:00
Stefan Karlsson
22e981ea87 OP-922 Mark PIOS_DEBUG_Panic with attribute noreturn 2014-08-16 16:57:50 +02:00
Alessio Morale
30df5de332 uncrustify 2014-08-13 15:54:52 +02:00