Support for receiver configuration (PPM, PWM and DSM)
There are still problems with Flexi port (not sure if related to a problem with my board) and Uart/SBUS that has the input always inverted.
CPU was being hammered with FIFO empty IRQs if we queued data but
the host wasn't actively draining the FIFO.
This was entirely unexpected so this hack should probably be
removed once we can figure out why this was happening.
This is almost certainly hiding some other issue.
Make sure we don't clobber our endpoint configuration by
double configuring an Rx or Tx buffer against it. Wait for
the completion of the previous operation before allowing
endpoint configuration again.
Upper (COM) layer was calling down into the HID layer before
the HID interface had been enabled. This was leading to
interacting with the endpoint Rx and Tx FIFOs prior to init.
The FIFO config was then being clobbered when we the USB IF
was eventually enabled.
Error flags being set were causing flash erase operations to
fail. Not sure why these flags were set though so this might
be hiding some other problem.
The F4 CPUs have 16KB x 4, 64KB x 1 and 128KB x 7 sectors
of flash. The FW image currently ends in the middle of a
128KB sector. FW_BANK is now increased to end on a sector
boundary.
The code in RCC_GetClocksFreq() uses HSE_VALUE to determine
the tick rate of the SYSCLK. This in turn is used by the
code in PIOS_DELAY_* to compute delays.
ST Library defaults this to 25MHz for the F4. Our board
actually has an 8MHz oscillator so delays were way off.
Mostly affects the bootloaders since most FW code uses RTOS
delays rather than busy-waiting using PIOS_DELAY_*.
HID driver was incorrectly giving back the HID interface
descriptor when asked for the HID descriptor. This should
let OP boards interact better with generic HID layer drivers
and also gives us nicer output in lsusb once the HID descriptor
is read.
Linux users can now cross-compile openocd to run on windows.
Here are the steps:
sudo apt-get install mingw32
make ftd2xx_install
make libusb_win_install
make openocd_git_win_install
(cd tools; zip -r openocd-win-patched.zip openocd_win/)
This should simplify rolling out new versions of the tool and
provides an example for how to cross-compile future tools as
well.
Removes hard-coding of JTAG interface config in the
<board>_program make macros.
This allows the use of STLINKv2 for F4 boards while
continuing to use the FOSS JTAG revB on F1 boards.
To make it closer to proposed design.
* Aligned the background OP logo to the bottom-right corner
* Don't upscale the OP logo
* Fixed width of community panel
* Changed the vertical layout of icons and community panel
* Fixed color of community panel titles
* Use styled text for next containing &,
this fixes rendering but "..." are not displayed
