This reverts commit 0ba605812e.
The real problem was not with this, but due to unexpected reverse
checkbox behaviour.
Reverse checkboxes are completely ignored at the start of calibration,
they can be even set checked initially. But change of checkbox does not
reverse the GCS control gadget display. This should probably be fixed.
For CopterControl the following make options are available:
USE_TELEMETRY=[YES|NO|1|3] (default is YES, USART1)
USE_GPS=[YES|NO|1|3] (default is NO, USART3)
USE_SPEKTRUM=[YES|NO|1|3] (default is NO, USART3)
USE_SBUS=[YES|NO|1] (default is NO, USART1 only)
It was tested being merged with OP-472_CorvusCorax_CopterControl-Guidance_v3
branch, Spektrum on USART3 and GPS on USART1 and seems to work.
Currently defaults mimic original behavior, that is, if USE_SPEKTRUM
is not defined - define USE_PWM and USE_GPS. Thsi should be refactored
later to make it configurable from the Makefile.
Also it was not ported to the OP MB: it currently does not support the
S.Bus hardware and still has original behavior with the patch. But this
is one more step to dynamic configuration of ports.
Added new unbrick_<board> targets for each board.
These targets use the stm32flash utility to install
a bootloader on to the board. This is a tool of
last resort and should not be used for normal firmware
upgrades.
Usage:
make unbrick_<board> UNBRICK_TTY=/dev/ttyUSB0
Where:
<board> is one of coptercontrol, pipxtreme,
openpilot, ins, ahrs
UNBRICK_TTY is set to the serial device connected
to the board.
This tool can be used as a last resort for
installing a bootloader to a completely bricked
board that is unresponsive to even the rescue
functionality in the GCS uploader gadget.
TODO: This should be dynamic in the future.
But for now define any compatile combination of:
USE_I2C (shared with USART3)
USE_TELEMETRY
USE_GPS
USE_SPEKTRUM
USE_SBUS (USART1 only, it needs an invertor)
and optionally define PIOS_PORT_* to USART port numbers
Defaults are:
#define PIOS_PORT_TELEMETRY 1
#define PIOS_PORT_GPS 3
#define PIOS_PORT_SPEKTRUM 3
#define PIOS_PORT_SBUS 1
#define USE_TELEMETRY
#define USE_GPS
Telemetry, GPS and PWM input are enabled by default.
